PE Pipe Pull Force and Installation Stresses Pull Force and Installation Stresses The procedures for designing the bore path for plastic pipe are basically the same as...
PE Pipe – Post Installation Loads and Deflections Post Installation Loads and Deflections Earth Pressure Coefficient: K=\tan^2\left( 45-\frac{\theta}{2}\right) Θ – Internal Friction Angle of Soil (degree) Arching Factor:...
Allowable Tensile Load For PE Pipe During Pull In Installation Introduction The ATL is the allowable safe pulling load that can be applied to a polyethylene pipe. If installation-applied stresses...
PE Pipe – Pull Force and Installation Stresses (Specific Radius of Curvature) Specific Radius of Curvature This procedure is for designing the bore path specific using radius of curvature calculations for plastic...
Pull Force and Installation Stresses – Vertical When pipes are installed by HDD, they often experience high tension loads, severe bending, and external fluid pressures. Often these...