This is used for purging or venting gas from a pipeline, compressor, meter, or regulator station piping. The piping blows down to atmosphere, whereas it is required to calculate the thrust force at the outlet of the pipe where fluid expansion takes place.
F – Thrust force, pounds
Q – Flow rate, MCFD
D – Diameter of opening, inch
G – Fluid specific gravity
P – Pressure downstream, psig
Input Parameters
Select the Thrust at Blow-Off application from the Steel Pipe – Design and Stress Analysis module.
Enter Case, Project Name, Location, Date, and any necessary notes.
Fill out all required fields.
Make sure the values you are inputting are in the correct units.